Areas and examples of use

Mining and agricultural conveyer systems

Natalstit is predominantly used for protection of metal or rubber surfaces against abrasion.

COATING OF CHUTE FEEDER – ZI JIN, BOR

10 mm thick curtain fixed.
Hardox sheet has a 3-month life cycle, the curtain shows no traces of wear after 9 months.

TURBINE COATING – KARIN KOMERC QUARRY

10 mm Natalstit coating.
Before the application of Natalstit, the metal would wear out in a month.
Two months after having it coated with Natalstit, the turbine is still in use.

BELT FEEDER – COPPER ORE

Manganese steel plates would get worn out and after three months require a replacement. 10 mm thick Natalstit was applied.
One year after, the plates were worn by approximately 30%.

COATING OF FLOTATION SYSTEM F200–F1000.

Instead of rubber, a 10 mm Natalstit was fixed.
Tubes installed one year ago are still in service.

COATING OF METAL SILOS – NEW FLOTATION, ZI JIN BOR

Silos coated with a 10 mm Natalstit.

CONVEYER BELTS – KOSTOLAC DRMNO

Coating of 30 mm conveyer belt edges, on both sides of the belt, with a 3 mm thick Natalstit. Formerly, conveyer belts would require replacement 2 to 3 times a year. After being coated with Natalstit, their life cycle reaches minimum 1 year.

CONVEYER BELT RUBBER CLEANERS

Coated with a 10 mm Natalstit and installed in Kostolac. Their life cycle is 2 to 3 times longer than that of rubber cleaners.

COATING OF METAL BASKETS

Coated with a 10 mm Natalstit, applying cold vulcanization.
After this, all areas were sealed using a polyurethane electrode, to prevent penetration of liquids and their contact with the metal.